Diy audio I have the fear but hopefully I can overcome it.
![Laughing :lol:](./images/smilies/icon/lol.gif)
I used aluminium composite and acrylic layers for my GL75. Couldn't tell you if it was a good material though.Chunk McDaniel wrote: ↑Tue Jul 03, 2018 1:51 am I am thinking about a plinth build for a Lenco l75. Has anyone got experience of these tables and plinth builds. What is the consensus on high mass or light and rigid builds.I am thinking of experimenting with some birch ply, mdf and Aluminium composite sheet which seems to be a sheet of polyethylene sandwiched between two sheets of aluminium all in about 6mm thick. Not sure if anyone has used this material before. My thinking is that each material will help to remove resonance at different frequencies. I was thinking of a 2 tier open skeletal design. I have a Pioneer pl600x at the moment which I really enjoy but if done properly will a lenco with a good arm be better. You never know Doc if I dont cock this up I may even get round to building those Isobaric units for my Cube 2's.
Diy audio I have the fear but hopefully I can overcome it.![]()