My DIY speakers -"J&N"

A place for DIY project discussions.
User avatar
Jororaitchev
Posts: 9
Joined: Mon Jan 24, 2022 3:43 pm
Location: Sofia
Has thanked: 0
Been thanked: 7 times
Bulgaria

Re: My DIY speakers -"J&N"

Unread post by Jororaitchev »

[/attachment]
My initial idea was, for a bass speaker 6.5 ", but once I assembled the pilot model and measured the internal volume of the cabinet, found that I had enough reserve even for a 10" speaker. I decided at this stage to use 8.5 ".
This is the first option;
The final decision;
"SEAS" - Excel / Tw-1 ", Mw-5" for center 2x 5.5 ", Bass-8.5" / and cross-over parts- "Intertechnik". Nominal impedance- 8 Ohm Frequency Range 30Hz-20kHz,Characterstic Sensitivity (2.83V / 1m) - 87db. Long Term-110W.
Attachments
F-.jpg
F-.jpg (134.08 KiB) Viewed 1046 times
1-V.jpg
1-V.jpg (67.41 KiB) Viewed 1046 times
1V.jpg
1V.jpg (57.55 KiB) Viewed 1046 times
Final.jpg
Final.jpg (60.7 KiB) Viewed 1046 times

User avatar
Jororaitchev
Posts: 9
Joined: Mon Jan 24, 2022 3:43 pm
Location: Sofia
Has thanked: 0
Been thanked: 7 times
Bulgaria

Re: My DIY speakers -"J&N"

Unread post by Jororaitchev »

After veneering the next steps are, to make the desired color , and the following finish manipulation , spraying with high quality automobile acrylic lacquer.

To obtain the desired gloss, after about the tenth layer, the surface after each new one subsequent layer (total about 20-25) is polished, the result is this end product;;
j-.jpg
j-.jpg (62.52 KiB) Viewed 890 times
Attachments
g.jpg
g.jpg (87.61 KiB) Viewed 890 times
g-.jpg
g-.jpg (96.67 KiB) Viewed 890 times
C-1.jpg
C-1.jpg (89.03 KiB) Viewed 890 times
4.jpg
4.jpg (29.04 KiB) Viewed 890 times
6.jpg
6.jpg (31.03 KiB) Viewed 890 times
c2.jpg
c2.jpg (77.27 KiB) Viewed 890 times
These users thanked the author Jororaitchev for the post (total 2):
slinger (Tue Feb 08, 2022 7:18 pm) • Ithilstone (Tue Feb 08, 2022 9:06 pm)

Post Reply