1. No ad-hominem
2. No spamming or shilling
Found a thread on the friendly forum
http://theartofsound.net/forum/showthre ... -Avondale)
Wish i could fabricate something like that but forget the crossover.
Note the LS3/5A comments!
I use the chop saw for anything that will fit in its clamp. I use a jigsaw for steel up to 3mm but anything thicker than that needs an angle grinder or this Makita petrol cut off saw. Angle grinders are not the safest thing, sometimes they can fly out of your hands and do you some damage . The petrol saw is much safer in that regard, just a bit unwieldy . Wish I had a plasma cutter
Here is all the steel to go in one speaker. 8mm angle x4, 5mm plates x3.
I put all the steel in (bluetack came in handy) and realised that with all that in I cant get the mid/bass driver in . So one of the side plates will need to go in after the driver has been put in - tried it and it works.
I have a plate for the back panel but not sure I am going to use the original back panel. Here is the Russian paper in oil 3.3uf cap.
It's a big bugger
Russian K75-10 Hybrid Paper and Polyethylene Terephthalate In Oil Capacitor
This Russian military capacitor is quite intriguing in its reported construction and in appearance that resembles a small grenade. Its dielectric is claimed to be a hybrid of paper and polyethylene terephthalate, which is essentially a type of Mylar, saturated in oil. There is some debate as to which Russian “oil” capacitor is the best, and while K40Y is widely recognized and used, some report K75-10 is the premium oil capacitor out of the Russian military.
- Posts: 3744
- Joined: Mon Feb 03, 2014 9:53 am
- Location: The end of the road in Suffolk Coastal.
I live alone in this my heaven, in my love (and) in my songs.
Been busy again & a bit more done.
Steel painted with hammerite black. Not had the courage yet to dope the tweeter
Found an oily substance in the gap around the neo magnet that the voice coil goes in . Is this ferrofluid ?