Remote power supplies
-
- Posts: 4185
- Joined: Mon Feb 03, 2014 9:53 am
- Location: The end of the road in Suffolk Coastal.
- Has thanked: 10 times
- Been thanked: 6 times
Re: Remote power supplies
Try shielding them first. Loads of wonderful amps out there with built in transformers in my experience.
Hanging on in quiet desperation is the English way...The time has gone, The song is over, Thought I'd something more to say...
- karatestu
- Posts: 5983
- Joined: Sun Jan 08, 2017 4:40 pm
- Location: North Yorkshire
- Has thanked: 1881 times
- Been thanked: 1418 times
Re: Remote power supplies
I agree. Trouble with shielding is that EMI goes right through most metals. Steel is better than aluminum or copper and thicker the better.Cast iron may be even better than steel. Mumetal often gets mentioned but its expensive
DIY FREE ZONE
-
- Posts: 297
- Joined: Mon Feb 26, 2018 2:18 pm
- Has thanked: 0
- Been thanked: 0
Re: Remote power supplies
Stu I can only give advice based on experience as I'm not that well read on the subject.
For the paradise all the heavy lifting in the psu is done in a separate case. This is connected by a four way lead .74mm quad core, carrying only + ' 300mA at 27v. In the phono box is a local shunt reg. Theres a measurable difference in psu noise if I add local decoupling, only 50uf at the ends of the cables just before the shunt. Cable Inductance effects are present even on short, 60cm leads, so adding the last cap in the mains filter right next to the load is a good bit of design. Even though the cables are short and about 10x thicker than current requirements dictate.
Itll be different for every circuit so simulation or measurement is required for best results.
For the paradise all the heavy lifting in the psu is done in a separate case. This is connected by a four way lead .74mm quad core, carrying only + ' 300mA at 27v. In the phono box is a local shunt reg. Theres a measurable difference in psu noise if I add local decoupling, only 50uf at the ends of the cables just before the shunt. Cable Inductance effects are present even on short, 60cm leads, so adding the last cap in the mains filter right next to the load is a good bit of design. Even though the cables are short and about 10x thicker than current requirements dictate.
Itll be different for every circuit so simulation or measurement is required for best results.
- karatestu
- Posts: 5983
- Joined: Sun Jan 08, 2017 4:40 pm
- Location: North Yorkshire
- Has thanked: 1881 times
- Been thanked: 1418 times
Re: Remote power supplies
Thanks for sharing your experience Simon.
I don't do measurements except with a dmm, ruler or my ears. Don't own a sillyscope and wouldn't know how to use it properly. I often think of borrowing the one doing the rounds on pfm but it would take me a month to actually learn to use it and be sure i was measuring properly.
I don't do measurements except with a dmm, ruler or my ears. Don't own a sillyscope and wouldn't know how to use it properly. I often think of borrowing the one doing the rounds on pfm but it would take me a month to actually learn to use it and be sure i was measuring properly.
DIY FREE ZONE
-
- Posts: 297
- Joined: Mon Feb 26, 2018 2:18 pm
- Has thanked: 0
- Been thanked: 0
Re: Remote power supplies
I found a decent resource on osciloscope techniques hard to fine, ended up asking an old lag how to and went from there.