HiFi Subjectivist ¦ Audio Forum ¦ NVA User Group

Posted: **Thu Feb 07, 2019 8:01 pm**

Supplied direct from amp so in theory they are full range I suppose- I will have doc modded 12” drivers or try my own dope!

Posted: **Thu Feb 07, 2019 8:44 pm**

Latteman wrote: ↑Thu Feb 07, 2019 7:54 pm Hi again, I’m just about to install a set of doc modded 8” drivers, I would like some advice on the appropriate approach- I have been testing the wiring of each 8” plus a tweeter (cap only)- i can do it parallel at a total 8ohmn load max or in series at 16ohmn max, is there a preference you recommended using an A20,
I have a separate A20 directly feeding 10” Fane drivers rated at 16ohmn each so thought to match the diy cubes to these?
Cheers

Your post makes no sense, if I read right tell me how you can put a capacitor protected tweeter in series with a bass /mid.

Posted: **Thu Feb 07, 2019 10:06 pm**

Yep, apologies- i suppose that is my lack of understanding and misuse of jargon- I have decided to play safe and run parallel- I was worried about the 10” Fanes rated at 16ohms going up against the cubes at 8 ohms
I do have a very simple crossover from the 3 way Pavanes I could use instead- this sounds best at the moment

Posted: **Thu Feb 07, 2019 10:43 pm**

Lack of knowledge. DC resistance of the coil which is all you are quoting is pretty meaningless apart from whether the amp drives current more than voltage or v versa.

This is incredibly basic watch what you are doing.

HiFi Subjectivist ¦ Audio Forum ¦ NVA User Group

Cubes diy

Re: Cubes diy

Re: Cubes diy

Re: Cubes diy

Re: Cubes diy