[/attachment]
My initial idea was, for a bass speaker 6.5 ", but once I assembled the pilot model and measured the internal volume of the cabinet, found that I had enough reserve even for a 10" speaker. I decided at this stage to use 8.5 ".
This is the first option;
The final decision;
"SEAS" - Excel / Tw-1 ", Mw-5" for center 2x 5.5 ", Bass-8.5" / and cross-over parts- "Intertechnik". Nominal impedance- 8 Ohm Frequency Range 30Hz-20kHz,Characterstic Sensitivity (2.83V / 1m) - 87db. Long Term-110W.
My DIY speakers -"J&N"
- Jororaitchev
- Posts: 9
- Joined: Mon Jan 24, 2022 3:43 pm
- Location: Sofia
- Has thanked: 0
- Been thanked: 7 times
Re: My DIY speakers -"J&N"
- Attachments
-
- F-.jpg (134.08 KiB) Viewed 1200 times
-
- 1-V.jpg (67.41 KiB) Viewed 1200 times
-
- 1V.jpg (57.55 KiB) Viewed 1200 times
-
- Final.jpg (60.7 KiB) Viewed 1200 times
- Jororaitchev
- Posts: 9
- Joined: Mon Jan 24, 2022 3:43 pm
- Location: Sofia
- Has thanked: 0
- Been thanked: 7 times
Re: My DIY speakers -"J&N"
After veneering the next steps are, to make the desired color , and the following finish manipulation , spraying with high quality automobile acrylic lacquer.
To obtain the desired gloss, after about the tenth layer, the surface after each new one subsequent layer (total about 20-25) is polished, the result is this end product;;
To obtain the desired gloss, after about the tenth layer, the surface after each new one subsequent layer (total about 20-25) is polished, the result is this end product;;
- Attachments
-
- g.jpg (87.61 KiB) Viewed 1044 times
-
- g-.jpg (96.67 KiB) Viewed 1044 times
-
- C-1.jpg (89.03 KiB) Viewed 1044 times
-
- 4.jpg (29.04 KiB) Viewed 1044 times
-
- 6.jpg (31.03 KiB) Viewed 1044 times
-
- c2.jpg (77.27 KiB) Viewed 1044 times
- These users thanked the author Jororaitchev for the post (total 2):
- slinger (Tue Feb 08, 2022 7:18 pm) • Ithilstone (Tue Feb 08, 2022 9:06 pm)